Fabrication process

The kitchen should be levelled with a tolerance of +/- 3cm. Sink, tap and hob should be installed in their respective positions.

We will arrive to prepare a template for the worktop. We will mark sink, hob, overhang, etc.

Next, we will cut the worktops based on the templates we’ve prepared. We will prepare the edges, cut an opening for the sink and polish the surface. We can fit the worktops after approx. 10 days. All upstands will be trimmed from 30mm to 20mm from the same slab, to make sure the colours match.

During the installation, we will make the joins using resin, use silicone to seal the sink and level all surfaces. All granite worktops are then protected using a sealant.

We can also fabricate drainer grooves for special orders.

Also for special orders, we can fabricate side panels joined at a 45 degrees angle.